Genuine  Shindengen Mosfet FH020AA Regulator/Rectifier Kit

     KIT INCLUDES
 * WEATHER PROOF CONNECTORS FOR SHINDENGEN REGULATORS
 *COMPLETE INSTALLATION INSTRUCTIONS WITH PICTURES
 *WEATHER PROOF MAXI FUSE HOLDER
  (MAXI FUSE HOLDER HAS 10GAUGE WIRE AND CAN HANDLE 55AMPS)
 *30Amp MAXI FUSE (BUSS BRAND)
 *3 FT OF 10 GAUGE COPPER MULTI STRANDED WIRE RED
 *3 FT OF 10 GAUGE COPPER MULTI STRANDED WIRE BLACK
 * RING TERMINALS 3M (POS. RING TERMINAL W/HEAT SHRINK END)
 *( 4) 3M BUTT SPLICE CONNECTORS (W/HEAT SHRINK ENDS WATER PROOF)

Beware of the copies out there now being sold they are substandard quality made in China I sell genuine Shindengen quality only. Note: the copies do not have a metal back they have black potting material only.

This is a UNIVERSAL regulator/rectifier kit and charging system upgrade kit.
The kit can be used to upgrade 2 wire and 3 wire stator systems on all makes and models of motorcycles.
This voltage regulator is great for replacing existing undersized or obsolete regulators.
The advanced MOSFET construction will run cooler than all OEM diode style regulators.
In addition, this rectifier has overheat protection, rather than burn up it will simply turn off for a while and cool off.
This regulator is capable of 50amp peaks & 30amps continuous 3 phase and 30amp single phase.

Maxi fuse protected, unlike circuit breakers which over time can get weak and are prone to nuisance tripping.

(NOTE)Not for motorcycles with 5 wire stators in which 2 of them are for brushes. And systems using non permanent magnet rotors.

 For your reference the mounting center to center is 68mm to 70mm using 6mm bolts the bolt center could be filled wider or a adapter plate could be made for other mounting applications.

Often the stator has failed and the regulator gets the blame. A stator is difficult to check completely as they often fail only when hot.
These simple checks will find some bad stators, but a stator that passes these checks may still be defective.

1. Check the resistance between the leads, this is normally under 1 or 2 ohms. If you have a 3 phase stator, the resistance between each of the 3 lead combination's (AB,AC,BC) should be equal. If you see higher resistance, or unequal resistances, the stator is bad.
2. Check the resistance to ground, it should be well over 10 Meg ohm.

Battery condition is important. No regulator can make up for a bad or weak battery.
If in doubt charge your  battery and have it load tested, or simply replace it.
ALWAYS START WITH A FULLY CHARGED BATTERY

NOTE ABOUT CRIMPED CONNECTIONS:

Crimping was invented by Amp Incorporated in 1941 as a solderless method for terminating wires and connectors.

When done right, a crimped connection can be much stronger and longer lasting than a soldered connection, and have electrical resistance of the equivalent length of wire. A properly done crimp is also gas-tight as well, not allowing oxidation to degrade it over time. Note your factory connections are all crimped.